Filter
Top Products
VNR 100 • Reference Information 24
Attaching the rack rails to a standard rack
The rack rails come in two sections.
NOTES:
• The rail assemblies are specific for left and right.
• The longer rail section attaches to the front of the rack.
• The shorter rail section attaches to the rear of the rack.
• The rear rail section goes to the outside of the front section (closer to the rack and
further from the VNR 100).
2
3
Adjust Sliding Rail
End Flange
Stud
Rail Slot
Rack Mounting Rail
Rail Mounting Brackets
4
1
Figure 18. Assembling the Rack Rails
1. Assemble rack rail by pressing the stud of the rear rail section through the expanded
hole of the front rail section.
2. With the stud seated in the slot of the front section, adjust the sliding rail until the total
length matches the depth of the rack.
3. Use the locking screws to secure the assembly at the required length.
4. If required, rail mounting brackets (up to three on each rail assembly) can be secured to
the bracket mounts on the outside surface of the rack rail.
End Flange
5 5
Adjust Sliding Rail
Rack Mounting Rail
Rail Mounting Brackets
Figure 19. Mounting the Rack Rails to a Standard Rack
5. Place the flanges against the front and back posts of the rack and secure the assembly
to the rack.
NOTES:
• Ensure that the right and left side assemblies are at the same height.
• Ensure the rail guides are facing forwards.