Filter
Top Products
VNR 100 • Replacing the VNR 100 Drives 17
7. In the browser address bar, enter the IP address of
the recorder followed by a colon and the port number
(127.0.0.1:8080). The login page opens (see the
figure to the right).
8. Enter the Username and Password.
NOTE: By default, the Username and Password
are both config.
9. Click Login. The VNR 100 Recorder Settings
page opens (see the figure to the right).
10. Set the Network Settings and Recorder Settings
as required (default values are shown).
11. Click Apply Changes.
12. Logout of the config screen.
13. Power down the unit.
14. Remove the mouse, keyboard, and monitor.
Network settings [eth0]
Recorder settings
User settings
Data disk
IP Address
Subnet Mask
Gateway
Serial
Controller IP
Controller port
MTU
New password
Confirm New password
192.168.254.254
255.255.0.0
192.168.254.253
192.168.254.254
5432
1500
1111999
mounted to /home/matrix_rec/Recording_Files
Disk free space: 19GB->98% used
formated to ext3
status:
Umount
Format
Apply Changes
Cancel Changes
Logout
VNMatrix recorder settings