Filter
Top Products
VNR 100 • Reference Information 21
Port Transport Usage
69 UDP TFTP Server, used for firmware upgrades
80 TCP HTTP data. Value is user definable; the default is 80. Used to
communicate between the web browser and the Enterprise Controller
554 TCP Real-time streaming protocol (RTSP) server.
5432 UDP Enterprise Controller outgoing and incoming control messages. Value
is user definable; the default is 5432. Only used on the device acting as
controller to communicate with other VN-Matrix devices
5555 TCP Old XML interface and old VN-Matrix recorder software application. No
longer used.
9998 TCP Command Line Interface (CLI) messages. Used to telnet to the
controller for sending text-based control commands.
9999 TCP Deprecated: Old remote control server, replaced by CLI (port 9998).
23 TCP Telnet (can be disabled).
161 UDP Used for simple network management protocol (SNMP) alarm access.
199 TCP Used for simple network management protocol (SNMP) alarm access.
4002 TCP Source stream information. Used to telnet to the VN-Matrix decoder to
view information about the source it is decoding.
5002 TCP Serial port bidirectional protocol (not data channel streaming).
6666 TCP Keyboard and mouse forwarding.
7777 UDP Upgrade daemon, local access only.
8000-8098
(even)
UDP RTP unicast or RTP multicast audio, video, whiteboard, and data
streams. Controller selects port number, starting at 8000. This is the
port number of the destination (receiver).
8001-8099
(odd)
UDP RTCP channel for audio, video, whiteboard, and data streams.
Grouped with the even-numbered stream (8000 with 8001, 8002 with
8003, and so on). This is the port number of the destination (receiver).
8000 TCP Video streams. This is the port number of the source (sender).
8100 TCP Audio streams. This is the port number of the source (sender).
8200 TCP Whiteboard streams. This is the port number of the source (sender).
8201 TCP Data streams. This is the port number of the source (sender).
9000 TCP HSI interface if using ThorDebug.
9001 UDP VN-Matrix outgoing and incoming control messages. Communicates
with port 5432 (or the user-defined port number) on the Enterprise
Controller.
9002 UDP Default port for collecting UDP traffic for data-transport. Value is
user-definable.
9996 TCP HLI server port.
9997 TCP Annotation server port.
NOTE: The ports highlighted in yellow accommodate most simple applications.