Filter
Top Products
VNR 100 • Replacing the VNR 100 Drives 15
Replacing the
VNR 100 Drives
There are two optional drive replacement kits for the Extron VNR 100:
• OS Drive Replacement Kit
• Media Drive Replacement Kit
The drives allow the recorder to be moved between secure areas without compromising
confidential data. The media drive kit also offers a convenient way to archive materials.
There are four drive bays on the front panel of the VNR 100. From left to right, they are
numbered 0 - 3. The OS drive is number 0 and the media drive is number1.
b a
Media Drive (drive #1)
OS Drive (drive #0)
c
Figure 14. Media Drive and OS Drive
OS Drive Replacement Kit
Replacing the OS Drive
ATTENTION: Never remove or insert the drive while the unit is powered on.
NOTES:
• The replacement drive does not have a default IP address assigned. This must be
set by the user.
• The OS drive is licensed to run only on the VNR 100 for which it was supplied and
cannot be used with any other VNR 100 unit.
• A label fixed to the top of the drive shows the serial number of the VNR 100 for
which it is intended to be used.
1. Switch the recorder off
by pressing and holding
down the power switch
(figure14,
a
) until the LEDs
(figure 14,
b
) flash red and
then go out.
2. Unplug the recorder.
3. Press the red catch. The lever arm
is released (see the figure on the right).