Filter
Top Products
Quick Start — USP 405, cont’d
USP 405 • Quick StartQS-6
Optimizing the Image f
or Standard Resolution Outputs (NTSC/PAL rates)
Default
Cycle
Input
DETAIL
MENU NEXT
Default
Cycle
press
3 times
If you are using an analog CRT display, use the crosshatch test pattern as a reference to converge the display.
To select the crosshatch pattern:
Set the USP to output the crop pattern, then use the display's positioning controls to position the image so
that you can see all sides on the display. To select the crop pattern:
NOTE At this point, sizing and centering on the display is complete.
Select an input. Set the test pattern either to crop (if the source is 4:3, see step 2 above), or to the appropriate
aspect ratio test pattern. Use the USP's sizing and centering functions to fill the pattern. To set the sizing or
centering:
See "Image Adjustments" (page 2-19).
NOTE
If the source is a DVD, set the DVD player to output a 16:9 aspect ratio prior to performing step 4.
For the RGB input sources (Inputs 1 and 2), use the source material that is to be displayed.
a. Use phase adjustment to reduce noise and achieve a clear and sharp image. To adjust pixel phase:
b. Use the horizontal filter adjustment to maximize the amount of detail and the vertical filter adjustment to
reduce the amount of flicker on the screen. To adjust the horizontal and vertical filtering:
See "Image Adjustments" (page 2-19).
c. Next, use the encoder filter to adjust the sharpness of the image to the desired level. To adjust the sharpness:
See "Encoder Filter submenu" (page 2-17).
For composite, S-video, and component video inputs use the detail setting to adjust the sharpness of the image.
To adjust the image detail, see step 4a above.
Save this setting into one of the input's three user memories. To save the setting to memory:
See "Memory Presets" (page 2-15).
MENU NEXT
Default
Cycle
press
4 times
press
4 times
MENU NEXT
Default
Cycle
press
4 times
press
4 times
MENU NEXT
Default
Cycle
press
4 times
press
2 times
MENU NEXT
Default
Cycle
press
2 times
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Default
Cycle
Input
CENTER
SIZE
or
NOTE For composite, S-video, and YUV inputs, the horizontal and vertical filtering adjustments are
replaced with a detail (sharpness) adjustment.
See "Test Pattern submenu" (page 2-17).