Filter
Top Products
Front Panel Features
See figure 2 below to identify the front panel features on the transmitter and receiver.
MTP RL 15HD RS Receiver
RGB
PEAKING
LEVEL
MTP SERIES
MTP RL 15HD RS SEQ Receiver
RGB
DELAY
PEAKING
LEVEL
RED
GREEN
BLUE
SELECT
MTP SERIES
6
7
1
61098 7
1
MTP T 15HD RS Transmitter
MTP SERIES
50 Hz
RECORD
60 Hz SPARE
EDID
SELECT
ON
1
4
5
3
2
Figure 2. MTP Front Panels
NOTE: Control signal ground pins may be labeled as or “G”. Audio ground pins may
be labeled as or .
The wiring and function are the same, whichever way your product is labeled.
a Power LED — The LED indicator lights when the unit is receiving power.
b Record LED — The LED indicator flashes red during the EDID recording process to
indicate a new EDID being written to memory. The LED returns to a solid green after the
write completes.
c Record button — The recessed record button is used to initiate recording of the EDID
of a display device (connected to the loop-out) to user-programmable memory position
0 on the rotary switch (
e
).
d Vertical frequency DIP switch — The first DIP switch selects the vertical frequency for
the pre-programmed EDID. When switched to OFF (default position), the EDID selected
by the rotary positions 1 through E are based on 60 Hz. When switched to ON, they are
based on 50 Hz. The second DIP switch, marked SPARE, is not used.
NOTE: When the EDID select rotary switch (
e
) is in position 0 or F, the setting of
the first DIP switch is not applicable because the user-recorded or attached
display EDID is being used.
MTP 15HD RS Series • Installation and Operation 6