Filter
Top Products
15
7 WORKING WITH MEMORY continued
E100 OWNER’S MANUAL
E100 OWNER’S MANUAL
Down/Min. buttons (5,6). You will see the memory page change
with each press. When the page of your choice is reached, stop
pressing.
3. When nished, either press/release the M.Scan/Page button, or
wait about 3 seconds, causing the memory page to be entered.
The clock (34) will reappear in the display’s upper right corner.
ACCESSING WHAT IS STORED INTO MEMORY
There are three ways to access what has been stored into memory:
Direct Memory Access, Memory Search and Memory Auto-scan.
These three methods are described below. When the memory page
and memory preset numbers appear in the upper right corner of the
display, as it will in the descriptions below, the radio is in MEMORY
ACCESS MODE. This mode can be exited any time with a press/re-
lease of the M.Scan/Page button (7).
Direct Memory Access
If you are already on the desired memory page, simply key- in the
memory number with the numeric keypad. For example, if the desired
radio station is in memory number 01, just press ‘0’, then ‘1’, and it
will go to memory 01.
If you rst need to change memory pages, see the previous section,
SELECTING/CHANGING MEMORY PAGES.
Memory Search
Memory Search enables manual searching through the memories
within a memory page, as shown below:
1. Press/release the M.Scan/Page button.
2. Use quick, short presses on the Up/Hour or Down/Min. buttons to
search through the memories.