Filter
Top Products
9
5 BASIC RADIO OPERATION continued
E100 OWNER’S MANUAL
E100 OWNER’S MANUAL
VOLUME AND TONE CONTROLS
• The volume control (23), labeled VOLUME, is located on the right
side of the radio. To change the volume, rotate the volume control
knob.
• The tone control (22), on the right side of the radio is labeled
LOW/HIGH. Use the position that you like best.
SELECTING FM, AM or SHORTWAVE
After turning on the E100, pressing the button labeled ‘FM/MW/SW
Band’ (11), allows selection of FM, AM and SW. Note that when the
AM band is selected, the display shows MW, not AM. The frequency
digits (36) appear in the lower portion of the display.. The local sta-
tions of the area that you are currently in will be heard on AM and FM.
Shortwave stations from around the world will be heard on SW.
SETTING UP AM AND FM OUTSIDE OF NORTH AMERICA
You can skip this section if you are in North America and just
purchased the E100. It is already set-up in the factory for use in
North America. If you travel to other world regions, make the changes
below as necessary.
Outside of North America, AM stations (MW in the E100’s display)
are spaced in 9 KHz tuning steps. The FM frequency range may be
different from that used in North America, e.g. like that used in Japan,
76-108MHz. To make these changes please see the instructions
titled SYSTEM SET CODE TABLE, on pages 21-22.