Filter
Top Products
5 BASIC RADIO OPERATION continued
10
TUNING IN STATIONS
Four Ways to Tune in Stations
Below, four ways to tune stations are described. They are Regular
Tuning, Auto-scan Tuning, Direct Frequency Entry and Fine Tuning.
1. REGULAR TUNING (also called manual tuning)
Quick, short presses of the Up/Hour-Down/Min. buttons (5,6)
enables tuning up or down frequency.
2. AUTO-SCAN TUNING
Pressing the Up/Hour or Down/Min. buttons (5,6) for just over 1
second enables automatic scan-tuning. The radio will then auto-
matically stop on the next station encountered. Use the Up/Hour
button to auto-scan upward in frequency and the Down/Min.
button to auto-scan downward in frequency.
3. DIRECT FREQUENCY ENTRY
When the desired frequency is known, it can be entered via the
numeric keypad (14) and the ‘Enter’ button (13). First, make sure
that the correct band is selected - AM, FM or SW.
Most AM and Shortwave frequencies are designated in kilohertz
(KHz), e.g. 810 KHz or 9475 KHz. All FM frequencies are designat-
ed in megahertz (MHz), e.g. 102.9 MHz. To enter such frequencies:
1. Press/release the ‘Enter’ (13) button.
2. Enter the frequency using the numeric keypad.
Sometimes Shortwave frequencies are designated in megahertz
(MHz). If you encounter such a shortwave frequency and it has
less than three digits after the decimal point (e.g. 15.10 MHz or
6.92 MHz), then use the following method to enter it. However, if
there are three digits after the decimal point (e.g. 15110 MHz or
E100 OWNER’S MANUAL