Filter
Top Products
17
Using Your Eos System
Resetting the ID to Default:
To reset the Base Station and Speaker/Receiver’s ID back to the factory default, do the
following:
1. Disconnect the power supply from the Base Station
2. UsingtheVolumeControlSwitch,turnoallpowertotheWirelessSpeakers/Receivers.
3. Whilepressingandholdingthe“LINK”buttonontherearoftheBaseStationreconnect
the power supply from the Base Station. Hold the link button for about 3 seconds.
4. Release“LINK”button
Note: all four “Wireless Speaker Link LEDs” on the Base Station will blink while in “Reset Mode”
5. TurnontheWirelessSpeakers/Receiverswithin60secondsofreleasingthe“LINK”button.
Note: Allow each Wireless Speaker/Receiver to Link before turning on the next Wireless Speaker/
Receiver. After completing steps 1-5, speakers will be set to the factory default ID and will be able
to link with your Base Station or any other Base Station with the factory default ID in the vicinity.
Range Extender:
The Range Extender Switch, located on the back of the Base Station, allows you to increase
the eective range of the Eos Wireless System. Use this button only if you are having
diculty linking up your Wireless Speakers/Receivers.
About“RangeExtender”-Tomaintainasolid,interferencefreelink,
the Eos system incorporates an advanced proprietary error correction
scheme. Error correction is done by creating a slight delay between
the transmitter and Wireless Speaker. Using this delay, Eos can conrm
that the audio packets arrive at the Wireless Speaker/receiver. If the
audio packet is not received, the Eos Base Station can resend it. Eos’
default delay (Range Extender O) is 20ms.
Turning on the Range Extender Switch increases the delay to 64ms. The increased delay
allows Eos to resend more audio packets due to distance from the transmitter or ambient
interference.
Note: Due to the 64ms delay, if an Eos Base Station and Wireless Speaker are in the same room,
a slight “echo” eect is apparent.