Filter
Top Products
14
The system memory remembers the Bass Boost setting when the power is shut
‘Off’ and automatically returns to the same setting when the power is switched ‘On’
again.
SETTING THE CLOCK
Notes:
A. The time appears on the display when the system is in the Off/Standby mode
or the TAPE function is selected.
B. The time can be set using the buttons on the front panel or on the remote
control.
1) Press the TAPE function button to select the Tape function. The display lights
and the time appears.
2) Press and hold the PROGRAM (CLOCK SET) button for more than one second.
The Hour digits begin to flash.
3) Press the SKIP/SEARCH / buttons to adjust the hour. Make sure the
hour is set correctly for AM or PM, and then press the PROGRAM (CLOCK
SET) button again. The Minute digits begin to flash.
4) Press the SKIP/SEARCH / buttons to adjust the minutes and then
press the PROGRAM (CLOCK SET) button once more to enter the setting
and start the clock.
Note: If you do not adjust the time within 20 seconds after pressing the PROGRAM
(CLOCK SET) button the display stops flashing and the time cannot be
adjusted. If this occurs repeat the clock setting procedure starting with
Step 2 above.
MS9600_ib_0313.p65 25/3/2002, 15:2314