Filter
Top Products
15
SETUPS
To set a Master
monitor as
System Controller
the TC Link
button on the rear
panel MUST be in
out-position.
5.1 Digital - 192 kHz
This is a 5.1 digital setup at 192kHz with Bass
Management as an option. The setup requires three
Master monitors with the optional Digital I/O card
installed, two Slaves and one Sub.
• Left monitor is set as System Controller by leaving out
the TC Link button on the rear panel.
• - Left monitor receives Left and Right Front channels.
- Center monitor receives Center channel and Sub.
- Left Rear monitor receives LS and RS channels.
• The Sub receives signal via TC LINK RJ-45 connections
from the Center Master monitor.
• Clock MUST be sent on the AES connection feeding
Center/LFE channels (or on BNC).
• With Bass-management “off” only the LFE signal is fed to
the Sub.
• With Bass-management activated, Low Frequency
information below the set Cross-over frequency from the
5 main channels is extracted and distributed to the Sub
where it is summed with the LFE channel.
• The Remote and/or AIR Soft, can be connected to any
available TC LINK Out connection.
To set a Master
monitor as
System Controller
the TC Link
button on the rear
panel MUST be in
out-position.
6.1 Digital - 192 kHz
This is a 6.1 digital setup with Bass Management as an
option. The setup requires four Master monitors with
the optional Digital I/O Card installed, two Slave
monitors (or Masters set as Slave) and one Sub.
• Left monitor is set as System Controller by leaving out
the TC Link button on the rear panel.
• - Left monitor receives both Left and Right Input signals.
- Right monitor receives signal via the TC LINK cable.
- Left Surround, receives both Left and Right surround
signals.
- Right Surround, receives signal via the TC LINK cable.
- Center receives both Center and Sub signals.
- The Sub receives signal via the TC LINK cable.
- Center Surround receives Center Surround channel.
• Clock MUST be sent on the AES connection feeding
Center/LFE channels (or on BNC).
• With Bass-management “off” only the LFE signal is fed to
the Sub.
• With Bass-management activated, Low Frequency
information below the set Cross-over frequency from the
6 main channels is extracted and distributed to the Sub
where it is summed with the LFE channel.
• The Remote and/or AIR Soft, can be connected to any
available TC LINK Out connection.
Air_US_rev_111.qxd 16-12-2004 14:16 Page 15