Filter
Top Products
Getting Started Connections Setup Playback Setting the Timer Other Functions Troubleshooting
ENGLISH
If a problem should arise, first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner’s manual?
3. Are the other components operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
Symptom Cause Countermeasure Page
Set does not
operate properly.
• External noise or interference is
causing the set to malfunction.
• Reset the microprocessor. 22
When the power
is turned on, the
power indicator
does not light
and no sound is
produced.
• Connection of the power cord is
faulty.
• Check that the power plugs are
securely inserted into the RCD-
CX1’s AC inlet and the wall power
outlet.
10
The power
indicator lights
but no sound is
produced.
• The speaker cables are not
properly connected.
• The function (input) is incorrect.
• The volume is set too low.
• Connect securely.
• Switch to the correct function
(input).
• Adjust the volume to an
appropriate level.
8
12
12
No sound is
produced from
one side.
• The speaker cables are not
properly connected.
• The input cables are not properly
connected.
• The left/right balance is off.
• Connect securely.
• Connect securely.
• Adjust the left/right balance.
8
8, 9
13
For stereo
sources, the
positions of the
instruments are
inverted.
• The connections of the speaker
cables or input cables are
inverted.
• Check and remedy the
connections.
8 ~ 10
GGeneralH
Troubleshooting
Troubleshooting Specifications
Symptom Cause Countermeasure Page
Disc tray does not
open.
• The power is not on. • Turn on the power. 12
“NO DISC” is
displayed even
though a disc is
loaded.
• The disc is not properly loaded. • Reload the disc. 3
“00 : 00” is
displayed even
though a disc is
loaded.
• A disc other than a CD or Super
Audio CD is loaded.
• Load a CD or Super Audio CD. 3
Playback does not
start even when
the 1/3 button is
pressed.
• The disc is dirty or scratched. • Wipe the dirt off the disc or
replace the disc.
3, 4
No digital signals
are output.
• For Super Audio CDs, no digital
signals are output.
• Turn the pure direct mode on.
• For Super Audio CDs, use the
analog audio output signals.
• Turn the pure direct mode off.
9
13
A specific section
of the disc
cannot be played
properly.
• The disc is dirty or scratched. • Wipe the dirt off the disc or
replace the disc.
3, 4
Programmed
playback is not
possible.
• The tracks have not been
programmed properly.
• Program properly. 15
A CD-R or CD-RW
disc cannot be
played.
• The disc has not been finalized.
• The recording conditions are bad
or the quality of the disc itself is
poor.
• Finalize the disc then play it.
• Use a properly recorded disc.
3
–
Files recorded
in MP3 or WMA
format cannot be
played.
• You have selected a copyright-
protected WMA file or a file that
cannot be played normally.
• Press the
8 or 9 button to
select a different file.
16
GCDH
1.RCD-CX1E3_ENG.indd 23 2008/06/30 11:12:55