Filter
Top Products
Getting Started Connections Setup Playback Troubleshooting
ENGLISH
Specifications
Setting the Sleep Timer
Use this function to automatically switch the power to the standby
mode after a specific amount of time (minutes).
The sleep timer can be set to up to 90 minutes, in steps of 10
minutes.
1
Select and play the desired function.
2
Press [SLEEP/TIMER] and select the setting time.
SLEEP 40SLEEP 30SLEEP 20SLEEP 10SLEEPOFF
SLEEP 90 SLEEP 80 SLEEP 70 SLEEP 60 SLEEP 50
b After about 5 seconds, the set returns to as it was before the
sleep timer was set.
n
Checking the time remaining until the sleep timer
starts
Press [SLEEP/TIMER].
n Canceling the sleep timer
Either press [SLEEP/TIMER] at step 2 under “Setting the Sleep
Timer” until “SLEEPOFF” is displayed, or press ON/STANDBY.
Last Function Memory
This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if operations
cannot be performed.
When the microprocessor is reset, all the settings are reset to
their default values.
1
Unplug the power cord.
2
Plug the power cord into a power outlet while pressing
<+/9> and <SOURCE> simultaneously.
After about 15 seconds “RESET” is displayed to indicate that the
microprocessor has been reset.
If “RESET” is not displayed in step 2, start over from step 1.
Convenient Functions
Auto Power On
When the power is in standby, the power turns on when any of
the buttons below other than ON/STANDBY is operated, and the
respective operation is performed.
•
<2/5> ··············The disc tray opens.
• 1/3 for the different functions
························
Playback of that source starts.
• [TUNER] ············Playback of the tuner starts.
• [2] ··················· Change the function to “CD” and switch the
power on.
• [PHONO] ··········· Change the function to “PHONO” and switch
the power on.
• [LINE1/LINE2] ···· Change the function to the finally set “LINE”
and switch the power on.
NOTE
When the iPod can be played, press [iPod 1/3] to start iPod
playback.
Auto Function Selector Function
When one of the buttons below is pressed, the function switches
to the respective function and playback of that source starts.
•
1/3 ················· The function switches to “CD” and the CD
starts playing.
• [2] ··················· The function switches to “CD” and the stop.
• [iPod 1/3] ········ The function switches to “iPod” and the iPod
starts playing.
• [TUNER] ············ The functions switches to “TUNER” and the
band last set is tuned in.
Other Functions
Other FunctionsSetting the Timer
1.RCD-CX1E3_ENG.indd 22 2008/06/30 11:12:55