Filter
Top Products
Getting Started Connections Setup Playback Setting the Timer Other Functions Troubleshooting
ENGLISH
Specifications
0
NOTE
• Insert the AC plugs securely. Incomplete connections could cause noise.
• When the power cord is plugged into the power outlet, the power indicator flashes orange for about 10 seconds.
Do not unplug the power cord before the power indicator turns off and the RCD-CX1 enters Standby mode.
• Only use the supplied power cord.
• Be sure the power cord is unplugged from the power outlet before connecting or disconnecting it to the AC IN.
Wait until all connections have been completed before connecting the power cord.
To household
power outlet
(AC 120 V, 60 Hz)
Power cord
(supplied)
Turning the Power On (vpage 12)
NOTE
• Make sure the AM loop
antenna lead terminals
do not touch metal parts
of the panel.
• Do not connect two FM
antennas simultaneously.
n Connecting the AM loop antenna
1
Push the lever.
2
Insert the conductor.
3
Return the lever.
AM / FM
The AM and FM reception sensitivity depends on the place the antenna
is set and the direction in which it is set. Set it so that reception is
best.
Antenna terminals
AM loop
antenna
(supplied)
FM indoor antenna
(supplied)
Connections to Other Devices Connecting the Power Cord
Once Connections are Completed
Connections
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s
attention to Article 820-40 of the NEC which provides guidelines
for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building,
as close to the point of cable entry as practical.
1.RCD-CX1E3_ENG.indd 10 2008/06/30 11:12:35