Filter
Top Products
51
NOTES:
• There are four Dolby Surround Pro Logic modes (NORMAL,
PHANTOM, WIDE and 3 STEREO). The AVR-2803/983 sets the
mode automatically according to the types of speakers set
during the system setup process (page 18).
• Dolby Surround Pro Logic
II is a mode in which 2-channel
sources are expanded into 5.1 channels.
To output a surround back channel in this mode, set the “SB CH
OUT” surround parameter to “NON MTRX”.
3
Set the surround parameter mode.
(Main unit) (Remote control unit)
MODE cinema
Display
The on-screen display differs according to whether the operation is performed from the
main unit or the remote control unit.
4
Select the play mode.
SELECT
(Main unit) (Remote control unit)
MODE cinema MODE music MODE DOLBY PL
5
Select the various parameters. (See “Surround parameters q” for a description of the various parameters.)
(Main unit) (Remote control unit)
MODE DOLBY PL
CINEMA EQ
MODE CINEMA
CINEMA EQ
MODE MUSIC
PANORAMA
DIMENSION
CENTER WIDTH
When set with the on-screen display using the remote control unit
while in the MUSIC mode, set the “” mark to “OPTION
0
”
using the D and H cursor buttons, then press the F cursor button.
Press the ENTER button to return to the previous screen.
6
Set the various surround parameters.
SELECT
(Main unit) (Remote control unit)
7
When the surround parameters are set using the buttons on
the main unit, stop operating buttons after completing the
settings. The settings are automatically finalized and the
normal display reappears after several seconds.
When the settings are made using the buttons on the remote
control unit, press the SURROUND PARAMETER button to
finish.
Surround parameters q
Pro Logic II Mode:
The Cinema mode is for use with stereo television shows and all
programs encoded in Dolby Surround.
The Music mode is recommended as the standard mode for
autosound music systems (no video), and is optional for A/V
systems.
The Dolby PL mode offers the same robust surround processing
as original Pro Logic in case the source contents is not of optimum
quality.
Select one of the modes (“Cinema”, “Music” or “Dolby PL”).
Panorama Control:
This mode extends the front stereo image to include the surround
speakers for an exciting “wraparound” effect with side wall
imaging.
Select “OFF” or “ON”.
Dimension Control:
This control gradually adjust the soundfield either towards the front
or towards the rear.
The control can be set in 7 steps from 0 to 6.
Center Width Control:
This control adjust the center image so it may be heard only from
the center speaker; only from the left/right speakers as a phantom
image; or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
Display
This is the screen when operated with the remote
control unit.
This is the screen when operated with the remote
control unit.