Filter
Top Products
45
After starting playback
[1]Adjusting the sound quality (TONE)
• The tone control function will not work in the direct mode.
• The tone control setting only affects the front speakers.
• If the tone control function is used, the main volume cannot be adjusted up to 18 dB. (The maximum main volume level differs in the different
surround modes.)
1
The tone switches as follows each time the TONE CONTROL
button is pressed.
(Main unit)
2
With the name of the volume to be
adjusted selected, turn the SELECT
knob to adjust the level.
SELECT
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
[3]Turning the sound off temporarily (MUTING)
1
Use this to turn off the audio output
temporarily.
Press the MUTING button.
Cancelling MUTING mode.
Press the MUTING button again or
adjust the main volume level.
1
1
• To increase the bass or treble:
Turn the control clockwise. (The bass or treble sound can
be increased to up to +10 dB in steps of 2 dB.)
• To decrease the bass or treble:
Turn the control clockwise. (The bass or treble sound can
be decreased to up to –10 dB in steps of 2 dB.)
[2]Listening over headphones
1
Plug the headphones’ plug into
the jack.
Connect the headphones to
the PHONES jack.
The pre-out output (including
the speaker output) is
automatically turned off when
headphones are connected.
1
PHONES
2 13
(Main unit)
(Remote control unit)
BASS TREBLE
3
If you do not want the bass and treble to be adjusted, turn on
the tone defeat mode.
The signals do not pass through the
bass and treble adjustment circuits,
providing higher quality sound.
[4]
Combining the currently playing sound with the desired image
1
Simulcast playback
Use this switch to monitor a
video source other than the
audio source.
Press the VIDEO SELECT
button, turn the FUNCTION
knob until the desired
source appears on the
display.
Cancelling simulcast playback.
• Select “SOURCE” using the VIDEO SELECT button and
the FUNCTION knob.
• Switch the program source to the component connected to
the video input.
111
(Main unit)
FUNCTION
IN=V SOURCE
Display