Filter
Top Products
2
ENGLISH
Getting Started Connections Playback Remote Control Information Troubleshooting SpecificationsMulti-Zone
Making the Optimum Settings for the Connected Speakers Automatically (Audyssey™ Auto Setup)
STEP5 Check
8
Use ui to select the item you want to check, then
press .
The measurement result
confirmation screen is
displayed.
b Subwoofer or other
speakers may be set to
a value that does not
correspond to the actual
distance.
9
Press .
This returns you to analysis results items, so repeat step 8.
10
Press i to select “Next 1 Store”, then press .
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ
STEP5 Check
Check processing res-
ults.To proceed,press
"Next"
Spkr Config Check
Distance Check
Ch.Level Check
Crossover Check
Next Store
ENTER Enter RETURN Cancel
Select item to check
[5/6]
STEP6 Store
11
Select “Store”, then
press .
“Now Storing... Please
wait.” is displayed on the
GUI menu while the results
are being stored.
NOTE
Do not turn the power off while the settings are being stored.
12
Disconnect the setup microphone from the AVR-
890.
13
Select “Exit” and then press .
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ
STEP6 Store
Press "Store" to store
calculation results.
Store
ENTER Enter RETURN Cancel
Apply and store measurement result.
[5/6]
Exiting the GUI Menu
Press while the GUI menu is displayed.
The GUI menu display disappears.
n
• If the result differs from the actual connection status or an error
message appears, use ui to GUI menu “Retry” and then press
to repeat the measurement.
• If the result still differs from the actual connection status after
re-measurement or the error message still appears, it is possible
that the speakers are not connected properly. Turn the AVR-890
off, check the speaker connections and repeat the measurement
process from the beginning.
• For instance, If the location or direction of a speaker is altered,
Audyssey Auto Setup should be performed again to ensure the
correct EQ solution for the new room configuration.
NOTE
Do not change the speaker connections or subwoofer volume,
or speaker locations after making measurements. If changes are
necessary, make the changes and use Audyssey™ Auto Setup once
again for an updated EQ solution.
: Moves the cursor (Up/Down/Left/Right)
: Decision the setting
: Return to previous menu
Remote control
operation buttons
:
Displaying the menu
Cancel the menu
Settings