Filter
Top Products
4
Use the “Up/Down” arrows to raise/lower the level from each channel, and use the
“Left/Right” arrows to select the channel to adjust. Take your time!
• We recommend that once you have completed adjusting the levels, to write down
and secure, the levels for every channel. This will help you to reset the system
quickly to reference if someone changes the levels, which you know will happen.
• Once finished press the “Enter” key. If you have the system exampled above, go
back into Channel Level and reconfigure the speakers for further level
adjustments.
.
Digital In Assignment
l This setting assigns the digital input jacks of the AVR-2802 to the different input sources
you have connected to it; i.e. DVD, CD, SAT, MD, CDR etc.
l Use the “Up/Down” arrow keys to select the input source you wish to adjust, then using
the “Left/Right” keys to select to digital input you have used for that source.
l Make note that no two sources can share the same digital input.
l For those input sources that have no digital inputs assigned, select ‘off’.
l When complete, press the “Enter” key.
On Screen Display
l This setting toggles the Display ‘On’ or ‘off’. For convenience sake, leave in the ‘On’
position.
Auto Tuner Presets
l This setting, when activated, will allow the AVR-2802 to automatically find and store into
memory, up to 40 FM radio stations. If a station with poor reception is not stored
automatically, you can manually store it into memory.
l Be sure an antenna is attached properly!
l When the AVR-2802 has finished searching and locking in stations into memory, the
Setup is complete. Simple press the System Setup button to exit out. Enjoy.