Denon AVR-2802/982 Stereo Receiver User Manual


 
ENGLISH
20
Setting the SB CH Auto Flag Detect
Set the operation for the digital signals when playing in the 6.1 SURROUND and DTS-ES surround modes.
1
At the System Setup Menu select SB CH Auto Flag
Detect and press the ENTER button.
ENTER
2
Select the desired setting.
We recommend setting this to
OFF.
When set to ON, then set the
operation for software for which
no identification signals are
recorded (Non-Flag Source).
3
Enter the setting.
The System Setup Menu reappears.
ENTER
Setting
q Auto Flag Detect Mode (AFDM)
ON: This function only works for sources containing DTS-ES or 6.1-channel surround identification signals.
When this function is used, sources that have been recorded in 6.1-channel surround or DTS-ES are automatically played in the 6.1-
channel surround mode using the surround back speaker(s). (Refer to w for the method of playback of the surround back speaker in
this case.)
OFF: Set this mode if you wish to play normal 5.1-channel sources or sources not containing the identification signals in the 6.1-channel
mode.
w Non-Flag Source SBch Output
MTRX ON: Sources are played using the surround back speaker(s). The surround back channel is played with digital matrix processing.
NON-MTRX: Sources are played using the surround back speaker(s). The same signals as those of the surround channel are output from
the surround back speaker(s).
OFF: Sources are played without using the surround back speaker(s).
NOTES:
The SB CH Auto Flag Detect setting screen is displayed when the surround back speaker(s) is/are set to Large or Small at the Speaker
Configuration screen.
The surround back speaker(s) can also be turned on and off with the 6.1/7.1 SURROUND button on the main unit. (See page 45.)