Filter
Top Products
Checking the XM Signal Strength and
Radio ID
1
Either turn <SOURCE SELECT> or press [SAT TU 1/2]
to select “XM”.
2
Press <STATUS> until “SIGNAL” appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
GOOD Signal strength is good
MARGINAL Signal strength is marginal
WEAK Signal strength is weak
NO No signal
3
Adjust the position of the antenna until “SIGNAL:
GOOD” is shown on the display.
4
Press <STATUS> until the station you want to check
(example: “XM001”) is displayed.
The strength of both the XM satellite and terrestrial signals can be
checked at menu “Input Setup” – “Antenna Aiming” (vpage 43).
1
Either turn <SOURCE SELECT> or press [SAT TU 1/2]
to select “XM”.
2
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE
CONTROL 2] to “TUNER”.
(vpage 65 “Remote Control Unit Operations”)
3
Use TUNING to select the station.
When the station is tuned in, the name of the track and artist
are displayed.
• The channel switches continuously when TUNING is pressed and
held.
• The artist name, track name, category and reception level can be
checked by pressing <STATUS>.
• The time for which the on-screen display are displayed can be set
at menu “Manual Setup” – “Option Setup” – “On-Screen Display”
(vpage 36).
Basic Operation
TUNING
PRESETSHIFT
op
<SOURCE SELECT>
<STATUS>
ui
TUNING
SHIFT
[CHANNEL +/–]
uiop
[SOURCE
CONTROL 1]
[SOURCE
CONTROL 2]
[SAT TU1/2]
TUNING
[MEMORY]
[SAT TU 1/2]
uiop
[Front]
[Rear]
Button located on both the main unit and the remote control
unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting
ENGLISH
Presetting Radio Stations
(Preset Memory)
Your favorite broadcast stations can be preset so that you can
tune them in easily. Up to 56 stations can be preset.
1
Tune in the broadcast station you want to preset.
2
Press [MEMORY].
3
Press SHIFT to select the block (A to G) in which the
station is to be preset.
4
Press <PRESET> or CHANNEL + – to select the preset
number (1 to 8).
5
Press [MEMORY] again to complete the setting.
To preset other stations, repeat steps 1 to 5.
NOTE
Preset stations are erased by overwriting them.
5
Press TUNING and select channel 0 (XM000).
The radio ID is shown on the display.
Radio ID