Filter
Top Products
j
Remote ID Setup
Set remote control ID.
[Selectable items]
1
2
3
4
k
232C Port
Set when external controller or 2-way remote control unit is
connected.
[Selectable items]
Serial Control
: Set when using an external controller.
2Way Remote
: Set when using a 2-way remote control unit.
NOTE
When using a 2-way remote control unit (RC-7000CI and RC-7001RCI,
sold separately), set this to “2Way Remote”.
NOTE
When using the AVR-2309CI with only the included remote
control unit (RC-1099), use Remote ID “1” (default).
When using a separately sold remote control unit (RC-7000CI, etc.),
this function can be used. Match the ID setting of the remote control
unit and the receiver.
For details on how to select, set and cancel settings for each menu, see “Menu Operations” (vpage 22).
Default
Resets the settings to the default values.
l
Display
Adjust display brightness of the receiver.
Operating from the main unit
Press <DIMMER>.
Bright Dim
DarkOFF
[Selectable items]
Bright
: Normal display brightness.
Dim
: Reduced display brightness.
Dark
: Very low display brightness.
OFF
: Display is off unless controls are operated.
A0
Setup Lock
Protect settings from inadvertent change.
• When “Setup Lock” is set to “ON”, the settings listed below can
no longer be changed. Also, “SETUP LOCKED!” is displayed if you
attempt to operate related buttons.
⋅ RESTORER
⋅ Night Mode
⋅ Parameter
⋅ MultEQ
⋅ Dynamic EQ
⋅ Dynamic Volume
⋅ Channel Level
⋅ Audio Delay
• To cancel the setting, press <MENU> or [A.MENU] to re-display the
“Setup Lock” screen, then change the setting to “OFF”.
[Selectable items]
ON
: Turn protection on.
OFF
: Turn protection off.
When setting to “OFF”, the display brightness of the menu setting in
operation changes to “Dark”.
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting
ENGLISH