Filter
Top Products
1.2 SPECIFICATIONS
1.2.1 STEREO SPECIFICATIONS
Output Power
Frequency Response
1 KHz Power
Harmonic Distortion
I.M. Distortion
(60Hz-7KHz
4:1)
Slewing Rate
Damping Factor
Output Impedance
Load Impedance
Voltage Gain
Input Sensitivity
Output Signal
155 watts per channel minimum RMS (both channels oper-
ating) into an 8 ohm load over a bandwidth of 1
Hz-20KHz
at
a rated RMS sum total harmonic distortion of 0.05% of the
fundamental output voltage.
±0.1dB
DC-20KHz
at 1 watt into 8 ohms;
±ldB
DC-100KHz.
180 watts RMS into 8 ohms, per channel, both channels operating, 0.1% total harmonic distortion.
Less than 0.001% from
20Hz-400Hz.
and increasing linearly to 0.05% at 20KHzat 155watts RMS
per channel into 8 ohms.
Less than 0.05% from 0.01 watts to 0.25 watts and less than 0.01% from 0.25 watts to
155watts
into 8 ohms, per channel.
8 volts per microsecond (slewing rate is the maximum value of the first derivative of the output
signal, or the maximum slope of the output
signal).
Greater than 750,
DC-400Hz
into 8 ohms.
Less than 7 milliohms in series with less than 3 microhenries.
Rated for 8 ohm usage; safely drives any load Including completely reactive loads.
20.6±2%
or
26.3±0.2dB
at maximum
gain.
1.75
volts±2%
for 155 watts into 8 ohms.
Unbalanced, dual channel.