Filter
Top Products
Crestron PROAMP(I)-7X400 PROCISE™ Surround Sound Amplifier
Override Mode
The Override mode turns on all amplifier channels and ignores any commands from
a control system or PSPHD (if connected). Use the Override mode to test the
amplifier prior to installation in a system. To use the Override mode:
1. With the amplifier powered on, press the OVERRIDE/SETUP button on
the rear of the PROAMP-7X400. The amplifier will be in the Override
mode and the associated LED will light.
2. Test the amplifier as needed.
3. Press OVERRIDE/SETUP to exit the Override mode. The LED will
extinguish.
Pairing
NOTE: Pairing is for use with the PSPHD only.
The PROAMP-7X400 can be paired with a PSPHD Surround Sound Processor for
control and monitoring of the amplifier. Use the connection type that best fits the
application:
• DIRECT: Choose DIRECT for a quick installation test without
networking or LAN setup. The LAN port of the amplifier connects directly
to the LAN port of the PSPHD.
The following diagram shows a typical system arrangement where a
PSPHD is directly connected to the amplifier.
Control
System
PSPHD PROAMP
Cresnet
Ethernet
To later integrate with a control system program controlling via the LAN,
the pairing process must be executed again when the amplifier is installed
on a network. The original pairing must be removed and then re-paired.
If the amplifier and PSPHD are to be controlled by Cresnet, pairing does
not need to be repeated.
• NETWORK: Choose NETWORK if you already have a DHCP network
available and plan to eventually control the amplifier and PSPHD over a
LAN.
The following diagram shows a typical system arrangement where a
PSPHD is connected to the amplifier over an Ethernet network.
For details on pairing the PROAMP-7X400 with a PSPHD, refer to the latest version
of the PROAMP-7X400 Quickstart (Doc. 6977) and the PSPHD Operations Guide
(Doc. 6837) which are available for download from the Crestron website.
Operations Guide – DOC. 6976A PROCISE™ Surround Sound Amplifier: PROAMP(I)-7X400 • 15