Filter
Top Products
Crestron PROAMP(I)-7X400 PROCISE™ Surround Sound Amplifier
• If an IP ID is set, Cresnet communication with the PSPHD is disabled. The
PROAMP-7X400 can use either a Cresnet connection or Ethernet
connection. It cannot use both.
Installation
Observe the following guidelines when installing the PROAMP-7X400:
WARNING: Failure to observe the following installation guidelines may result in
personal injury or damage to the equipment.
• The PROAMP-7X400 is very heavy. Two people should lift and install the
device.
• The installation location must be able to support the weight of the
PROAMP-7X400 (108 lbs (49.0 kg)).
Ventilation
The PROAMP-7X400 should be used in a well-ventilated area. The venting holes
should not be obstructed under any circumstances.
To prevent overheating, do not operate this product in an area that exceeds the
environmental temperature range listed in the table of specifications. Consider using
forced air ventilation and/or incrementing the spacing between units to reduce
overheating. Consideration must be given if installed in a closed or multi-unit rack
assembly since the operating ambient temperature of the environment may be greater
than the room ambient temperature. Contact with thermal insulating materials should
be avoided on all sides of the unit.
Rack Mounting
The PROAMP-7X400 can be mounted in a rack or stacked with other equipment.
Two “ears” are preinstalled so that the unit can be mounted in a rack.
WARNING: To prevent bodily injury when mounting or servicing this unit in a
rack, take special precautions to ensure that the system remains stable. The following
guidelines are provided to ensure your safety:
• Load the rack from the bottom to the top with the heaviest component at the
bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the unit in the rack.
NOTE: The PROAMP-7X400 is shipped with “feet” installed so it can be stacked
with other equipment. If the PROAMP-7X400 is to be installed in a rack, remove the
feet using a #2 Phillips screwdriver. If rack mounting is not required, leave the feet
attached to the PROAMP-7X400.
NOTE: Reliable earthing of rack-mounted equipment should be maintained.
Particular attention should be given to supply connections other than direct
connections to the branch circuit (e.g. use of power strips).
Operations Guide – DOC. 6976A PROCISE™ Surround Sound Amplifier: PROAMP(I)-7X400 • 11