Filter
Top Products
7
Unpacking and Placement
unpacking your
surround processor
Carefully unpack your surround processor according to the supplied instructions, and
remove all accessories from the carton.
Important! Keep all packing materials for future transport of your Classé product.
Shipping your new component in anything other than its purpose-
designed packing material may result in damage that is not covered by
the warranty.
placement As with any surround processor, it is best to place the SSP-300 centrally within your
system, since it is the hub to which all other components are connected. It should also
be located at a convenient height for both visibility and use, since you generally interact
with your surround processor more than any other component (changing inputs,
adjusting volume, etc.).
Note that adequate clearance for the AC cord and connecting cables must be
left behind the SSP-300. We suggest leaving eight inches (20 cm) of free space
behind your surround processor to allow all cables sufficient room to bend
without crimping or undue strain.
Classé recommends that the unit not be placed directly on the top surface of a power
amplifier (or any other heat source).
ventilation Your Classé surround processor generates a certain amount of heat in the course of
normal operation. Be sure to allow three inches of clearance above it and three inches
to each side to allow heat dissipation through air circulation. Avoid placement on soft
surfaces that would restrict airflow (such as plush carpeting).
custom installations Drawings are included in this manual to facilitate special installations and custom
cabinetry (see the section Dimensions). An optional, purpose-designed rack mount kit is
available for this product. Contact your Classé dealer for more information.
serial number The serial number for your surround processor is found on the rear of the unit. Please
note and record this number on the page entitled Important Safety Instructions for your
future reference.