Filter
Top Products
49
• autocalibration uses the provided microphone to calibrate the system
automatically for optimal performance in each of these four positions.
Simply plug in the microphone to the mic input on the rear panel, place the
microphone at the desired position, and then press auto levels and auto delays
in turn, allowing the SSP-300 to run its tests and establish the correct settings
for you.
• manual levels adjusts the speakers levels manually as you might have done with
other surround processors. A noise sequencer is available to provide a reference
signal for adjustment purposes. Holding a dB SPL meter at the listening
position, at arm’s length, and pointing straight up at the ceiling, adjust the level
of each speaker in turn until it reads 75 dB SPL when the meter is set to “C”
weighting and Slow response.
• manual distance adjusts the distances settings manually as you might have
done with other surround processors. Simply measure the distance with a tape
measure or equivalent, and enter the distance into the menu. The SSP-300 will
automatically convert this distance to the appropriate delay.
profiles This design feature is intended to allow the user to create a number of shortcuts
to various functions of your surround sound processor. Two separate profiles, with
up to six commands for each can be created. Additionally, a new name, up to 14
characters long, can be assigned to these two buttons. Once the “in use” button
is highlighted, the new profile button will appear on the home page. You can also
assign OSD to these preferences.