Filter
Top Products
26 WXZ466MP
280-8171-00
English
8. TROUBLE SHOOTING
Power does not
turn on.
(No sound is
produced.)
No audio when
operating the unit
with amplifiers.
Nothing happens
when buttons are
pressed.
No audio.
“Push EJECT” is
displayed.
“FAIL ****” is
displayed.
No audio.
Sound skips or is
noisy.
Problem
Fuse is blown.
Incorrect wiring.
Amplifier turn-on lead is
shorted to ground or
excessive current is required.
The microprocessor has
malfunctioned due to noise,
etc.
The speaker protection
circuit is operating.
Something is wrong with disc
or mechanism.
Anti-theft function is out of
order.
MP3/WMA files are absent
on the disc.
Files are not recognized as
an MP3/WMA file.
File system is not correct.
Disc is dirty.
Disc is heavily scratched or
warped.
Replace with a fuse of the same amperage. If the
fuse blows again, consult Clarion dealer.
Consult Clarion dealer.
Turn the unit off and check each wire for a possible
short. If the amplifier turn-on lead shorts out, cover it
with insulation such as tape.
1. Check the speaker connection.
2. Turn down sound volume. Function can also be
restored by turning the power off and on again.
3. If the sound is muted again, consult Clarion
dealer.
Press the [Q] button to avoid the trouble.
If the situation is not improved despite you press the
[Q] button several times, please consult Clarion
dealer.
Press and hold the reset button for 2 seconds or
longer. If the situation is not improved, please consult
Clarion dealer.
Write MP3/WMA files onto the disc properly.
Use MP3/WMA files encoded properly.
Use ISO9660 level 1, 2 or JOLIET or Romeo file system.
Clean the disc with a soft cloth.
Replace with a disc with no scratches.
Cause
General
Press the reset button for
about 2 seconds with a thin
rod.
Measure
CD/MP3
+WXZ466MP-009-ENG 05.9.13, 10:5026