Filter
Top Products
English
35
DXZ575USB
9. ERROR DISPLAYS
If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
Error Display Cause Measure
CD/MP3/WMA/AAC
ERROR 2
A CD is caught inside the CD
deck and is not ejected.
This is a failure of CD deck’s mechanism and consult
your store of purchase.
ERROR 3
A CD cannot be played due
to scratches, etc.
Replace with a non-scratched, non-warped-disc.
ERROR 6
A CD is loaded upside-down
inside the CD deck and does
not play.
Eject the disc then reload it properly.
CD changer
ERROR 2
A CD inside the CD changer
is not loaded.
This is a failure of CD changer’s mechanism and
consult your store of purchase.
ERROR 3
A CD inside the CD changer
cannot be played due to
scratches, etc.
Replace with a non-scratched, non-warped disc.
ERROR 6
A CD inside the CD changer
cannot be played because it
is loaded upside-down.
Eject the disc then reload it properly.
DVD changer
ERROR 2
A DISC inside the DVD
changer cannot be played.
This is a failure of DVD mechanism and consult your
store of purchase.
ERROR 3
A DISC cannot be played due
to scratches, etc.
Retry or replace with a non-scratched, non-warped-
disc.
ERROR 6
A DISC inside the DVD
changer cannot be played
because it is loaded upside-
down.
Eject the disc then reload it properly.
ERROR P
Parental level error Set the correct Parental level.
ERROR R
Region code error Eject the disc and replace correct region code disc.
iPod
ERROR 1
A communication error
occurs between the iPod and
the iPod CeNET Controller.
Disconnect the iPod, then connect it again.
NO IPOD
There is no iPod connected. Please connect the iPod.
USB
ERROR 1
Device mechanism is
damaged.
The unit’s mechanism may be damaged. Consult
your dealer.
NO FILE
USB memory device contains
no audio files.
Insert USB memory device containing audio files.
DSP ERROR
USB connector is short-
circuited or USB memory
device is overloaded.
Disconnect USB memory device, then hold [
SRC
]
button depressed to turn power OFF. Then press
[
SRC
] button once again to turn power ON.
DXZ575USB_EN.book 35 ページ ２００６年１２月２５日 月曜日 午後１２時５７分