Filter
Top Products
Basic Operations
English
13
DXZ575USB
●
Adjusting the treble
The treble gain and treble FREQ (center
frequency) can be adjusted as follows.
The adjustment can only be performed when
the DZE is set to “
DZE OFF
”.
2-1. Select “
TREBLE
”.
2-2. Press the [ ] button.
2-3. Push the [
SEEK PANEL
] leftward or
rightward and select from:
“
T GAIN
”
↔
“
T FREQ
”
3-1. Press the [
UP
] or [
DN
] button to adjust the
gain and FREQ (center frequency).
T GAIN
: –6 to +6 (The factory default
setting is “
0
”)
T FREQ
: 8KHz/12KHz (The factory default
setting is “
12K
”)
3-2. Press the [ ] button to return to the
previous mode.
●
Adjusting the sound restorer
The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.
2-1. Select “
S RESTOR
”.
3-1. Press the [
UP
] or [
DN
] button to adjust.
Each time you press the [
UP
] or [
DN
]
button, the sound restorer changes in the
following order:
“
OFF
”
↔
“
1
”
↔
“
2
”
↔
“
3
”
∗
The factory default setting is “
OFF
”.
Set this adjustment in accordance with the
music source used.
OFF:
For music sources compressed at
high bit rate
1:
For music sources compressed for high
quality at low bit rate
2:
For music sources compressed for
standard quality at low bit rate
3:
For music sources compressed for low
quality at low bit rate
●
Setting high pass filter
2-1. Select “
HPF
”.
3-1. Press the [
UP
] or [
DN
] button to select the
setting. Each time you press the [
UP
] or
[
DN
] button, the setting changes in the
following order:
“
THROUGH
”
↔
“
50Hz
” ↔ “80Hz” ↔
“120Hz”
∗ The factory default setting is “THROUGH”
(through).
● Setting low pass filter
2-1. Select “S-W LPF”.
3-1. Press the [UP] or [DN] button to select the
setting.
Each time you press the [UP] or [DN]
button, the setting changes in the following
order:
“THROUGH” ↔ “50Hz” ↔ “80Hz” ↔
“120Hz”
∗ The factory default setting is “THROUGH”
(through).
● Adjusting the balance
2-1. Select “BALANCE”.
3-1. Press the [UP] button to emphasize the
sound from the right speaker, press the
[DN] button to emphasize the sound from
the left speaker.
∗ The factory default setting is “CENTER”.
(Adjustment range: L12 to R12)
● Adjusting the fader
2-1. Select “FADER”.
3-1. Press the [UP] button to emphasize the
sound from the front speaker, press the
[DN] button to emphasize the sound from
the rear speaker.
∗ The factory default setting is “CENTER”.
(Adjustment range: R12 to F12)
DXZ575USB_EN.book 13 ページ ２００６年１２月２５日 月曜日 午後１２時５７分