Filter
Top Products
While driving, keep the volume to a level at
which external sounds can be heard.
Turning on and off the monitor
Each time you press the MONI button , the
monitor is turned on and off.
*
While using the rear vision camera, monitor-off
mode is canceled. When a button other than the
ENT button , the TAPE button , SLOPE but-
ton , or CD button is pressed, monitor-off
mode is canceled.
Mute
Each time you press (center) of the ENT
button , mute is turned on and off.
“MUTE” is displayed when mute is turned on in
radio mode, and “PAUSE” is displayed in tape,
CD or CD changer mode.
Adjusting the balance
1) Press the A-M button to go to the BAL-
ANCE display.
Note:
•
If no setting is made 5 seconds after pressing the A-
M button , the unit returns to the previous mode.
2) Slide the Up/Down button to (left),
(right), (up), or (down) to adjust the
balance of the speakers.
: Increases the volume of the left speaker.
: Increases the volume of the right speaker.
: Increases the volume of the front speaker.
: Increases the volume of the rear speaker.
3) Press the A-M button to return to the pre-
vious mode.
*
The tone is adjusted with the equalizer. For
information on equalizer operation, see the
section “Operating the Equalizer.”
Adjusting the operation panel to a
good viewing angle
Adjust the operation panel to an appropriate angle
to watch the display and operate the buttons.
Do not place foreign objects in the Cassette
Insertion slot or the CD Insertion slot .
When adjusting the angle of the panel, be care-
ful not to let your fingers get caught in the panel.
1) While the SLOPE button is held down, the
operation panel tilts.
If you press and hold the SLOPE button ,
the panel turns upward to the maximum
angle and stops.
2) When the operation panel is set to the maxi-
mum angle, pressing the SLOPE button
closes the panel.
*
The operation panel angle can be stored. For
details, see the next subsection.
Notes:
•
Do not place any object on the operation panel.
•
Do not expose the operation panel to shocks.
Storing the operation panel angle
When the operation panel angle is stored, it is
set to that angle after a CD or cassette tape is
inserted.
1) Press the SLOPE button to set an appro-
priate operation panel angle.
2) Press the ADJ button to go to the CON-
FIGURATION display.
3) Slide the Up/Down button to (up) or
(down) to move the cursor to “VIEW
ANGLE.”
4) Press (center) of the ENT button .
11
11
10
2
2
2
2
3130
SLOPE button
2
CD Insertion slot
31
6
11
6
Balance of the front
and rear speakers
Balance of the left
and right speakers
6
11
32
1
11
25
15
English
Owner’s Guide
CAUTION