Filter
Top Products
29
English
Owner’s Guide
2) Slide the Up/Down button to (down) or
(up) to move the cursor to “BEEP.”
3) Each time you slide the Up/Down button
to (right), the beep sound is turned on
and off.
4) Press the ADJ button to return to the pre-
vious mode.
Titling
You can title a radio station or CD name (title)
and store them. When the titled station is tuned
in or the CD is played, its title appears in the dis-
play.
Entering a title
Notes:
•
Up to 30 FM band and 20 AM band stations can
be titled. Also 50 CDs can be titled.
•
If you try to input more than the specified number
of titles, “OVER FLOW” appears in the display and
further input becomes impossible. Delete unnec-
essary titles to input new ones.
1) Select a station or CD which you want to title.
2) Press the TITLE button and select the title
input display.
*
Each time you press the TITLE button , the
display switches in the following order.
3) Press button and to select the letter
type.
Button : Upper case letters and figures
Button : Lower case letters and symbols
4) Slide the Up/Down button to (up),
(down), (left), or (right) to move the
pink cursor to the letter you want to enter.
Press the (center) of the ENT button .
The selected letter is entered at the cursor
(black) on the top of the display.
*
Repeat steps 3) and 4) above to enter the title.
*
If you entered the wrong letter, press the but-
ton to backspace the cursor (black) and
enter the correct letter this time.
*
Press the button . The cursor (black) moves
to the right.
5) After entering the title, press and hold
(center) of the ENT button for about 2 sec-
onds. The title is stored when the beep
sounds and the previous mode is recalled.
Note:
•
The title list in radio mode displays only titles for
the preset stations.
Clearing the title
1) Select the mode where the title you want to
clear is stored (radio or CD mode).
2) Press the TITLE button twice in CD mode
or 3 times in radio or CD changer mode to go
to the TITLE CLEAR display.
3) Slide the Up/Down button to (down) or
(up) to move the cursor to the title you
want to clear and press and hold (center)
of the ENT button for about 2 seconds.
The title is cleared when the beep sounds.
4) Press the TITLE button to return to the
previous mode.
Changing the title
1) Select the mode where the title you want to
change is stored (radio or CD mode).
2) Press the TITLE button to select the title
input display.
Change the title using the procedure
described in step 3) above and in the sub-
section “Entering a title.”
23
23
11
11
23
11
21
20
11
11
17
16
1716
Title input display TITLE SELECT
Previous mode TITLE CLEAR
23
23
10
11
11