Filter
Top Products
23
Speciality Features
Display Button: The factory default setting is clock display priority. Push the
DISPLAY button at any time to display the radio frequency, CD track, AUX
1 or AUX 2.
Note: In the Sirius mode the factory default setting is Sirius channel
display priority. Push the DISPLAY button at any time to display the
CN-NAME, SONG TITLE, ARTIST, CATEGORY and Clock. If clock is cho-
sen the time will be displayed for approximately 5 seconds then revert to
displaying the Category.
DISP
EQ
BAND W-BND
ENTER
Restoring Factory Default Setting: To restore the radio to the factory default
setting:
1. Press the
MODE button to select the radio band
.
2. Push the BAND button and and hold until “EEP INIT” appears in the
display. All settings will be restored to the factory default.
MODE AS/PS
Reset Button:
The radio panel or LCD display may fail to function normally
due to the vehicle’s battery condition, and may require resetting the radio
microprocessor if:
• The vehicle has been “jump started” from a dead battery condition.
• The vehicle battery becomes very low and is quick-charged.
• The vehicle battery is removed and replaced.
Should this condition occur, simply press and release the RESET button
on the radio panel using the tip of a ball point pen. This will reset the
radio microprocessor to the original factory settings. After pressing the
RESET button you should recheck to see if the radio functions normally.
All station programming should remain, but you will have to reset the
clock. Should the LCD display area show any abnormal error code, please
refer to the trouble shooting guide and solution chart below.
Error Code Problem Description Possible Remedy
ERR 1 Mechanism Problem Unknown mechanical 1. Eject the disc and try another.
problem with the CD 2. Press the reset button.
mechanism. 3. Replace the unit.
ERR 2 TOC Reading Error Laser can not read the 1. Insert a different disc.
CD disc table of 2. Check disc for excessive scratches.
contents. 3. Check disc for dirt and fingerprints.
Clean disc and reinsert.
ERR 3 Error from High The temperature of the Reduce the temperature inside the vehicle
Ambient Temp. mechanism is too high and try to play a CD at a later time.
to play CDs without
damaging them.
ERR 4 DVD Error Error during playback 1. Insert a different disc.
of disc. 2. Check disc for excessive scratches.
3. Check disc for dirt and fingerprints.
Clean disc and reinsert.
4. Press the reset button.
ERR 5 Disc Error Error during eject 1. Push the reset button.
and loading disc. 2. Replace the unit.
M9900DVDS-UM 4/26/06 14:16 Page 23