Filter
Top Products
11
③
④ ①⑤
⑥
⑪
⑦
⑨
⑧
⑩
⑥
Connect the S-VIDEO output signal from
video equipment to this jack (p.17).
⑧
Connect the audio output signal from
video equipment connected to ⑥ or ⑨ to
this jack. For a mono audio signal (a single
audio jack), connect it to the L (MONO)
jack (p.17).
⑩
Connect the audio output (stereo) from a
computer or video equipment connected
to ② or ③ to this jack (pp.16, 18).
⑨
Connect the composite video output signal
to this jack (p.17).
③
Connect output signal from a computer, RGB
scart 21-pin video output or component video
output to this terminal (pp.16,18).
⑤
Connect an external audio amplifier to this
jack (pp.16-18).
This terminal outputs sound from AUDIO IN
terminal (⑧, ⑩ or ⑪), or HDMI terminal (2)
(digital audio).
Never plug headphones and earphones into
this jack.
①
Connect the LAN cable (refer to the user’s
manual of "Network Set-up and Operation").
⑦
When controlling the projector with
RS-232C, connect the control equipment
to this connector with the serial control
cable.
④
– Connect computer output to this terminal
(p.16).
– This terminal can be used to output the
incoming analog RGB and Component
signal from COMPUTER IN 1/
COMPONENT IN terminal to the other
monitor (pp.16,18).
⑪
Connect the audio output (stereo) from a
computer or video equipment connected
to ④ to this jack. Or connect the MIC to
the this jack (pp.16, 18).
②
②
Connect the HDMI signal (including sound
signal) from video equipment or from
computer to this terminal (pp.16, 17).
is registered trademarks of HDMI
Licensing, LLC.