Filter
Top Products
540R v3azur
7
ENGLISH
Remote control
Tuner AM/FM
Selects Tuner mode. Pressing again to toggle between FM
and AM modes.
6.1 Direct
Selects the 5.1/6.1 Direct input.
PTY (Program Type Search)
Press to search by program type when in Tuner mode.
Refer to the ‘Operating instructions’ section of this manual
for more information.
APS (Auto Program Search)
Hold down for 4 seconds to allocate and memorise radio
stations automatically.
Display
Press to view the current source material and decoding
mode. When listening to FM with RDS, press to cycle
round various RDS information modes.
Stereo Mono
When listening to the FM tuner, press to alternate between
stereo and mono modes.
Store
Press to store the current frequency when in Tuner mode.
Mode
Press to select Auto/Manual or Preset tuning when in
Tuner mode.
DVD, Video 1, Video 2, Video 3, Tape
MD/CDR, CD Aux
Press the corresponding button to change the input
source.
The above button descriptions are naturally brief. Please
refer to the ‘Operating instructions’ section of this
manual for more information on the relevant functions
implemented.
The 540R v3 is supplied with an Azur Navigator remote
control. Insert the supplied AAA batteries to activate. For
full details of the various adjustment functions available
from the remote, refer to the later sections of this manual.
Standby/On
Switches the unit between On and Standby mode.
Audio In Type
Selects between analog or digital audio input for the
current source.
Stereo, PLII/NEO 6, DD EX/DTS ES, DSP Modes
See button details as listed in the ‘Front Panel Controls’
section on the previous page.
DRC (Dynamic Range Control)
Press to rotate through four dynamic range settings when
listening to Dolby Digital/DTS movie soundtracks. Refer to
the ‘Operating instructions’ section of this manual for
more information.
LFE Trim
Press to trim (adjust the level of) the Low Frequency
Effects channel using the Volume up/down buttons.
Sub On/Off
The Sub On/Off button performs temporary muting of the
Subwoofer without affecting the bass management or
speaker settings. Pressing the Sub On/Off button again or
selecting another decode mode cancels Sub Mute.
To make permanent settings to the speaker options
including the Subwoofer, use the ‘Speaker Config Menu’
in the On Screen Display (OSD).
Also, hold down and then press the volume up and down
buttons to adjust the overall sub level if desired.
On-screen Display (OSD)
Press to access the on-screen set-up menu when
connected to a monitor/screen via composite or S-video
connections.
Bass Treble
Press for bass/treble adjustment, using the Volume
up/down buttons.
Mute
Mutes the audio on the AV Receiver. Press again to cancel
mute.
Volume
Increase or decrease the volume of the AV receiver
output. Also used as up/down in the OSD setup menu.
Tune / Left & Right
Press the right arrow to increase tuner frequency/change
preset. Press the left arrow to decrease tuner
frequency/change preset. Also used to scroll left/right in
the OSD setup menus.
Enter
Used in the OSD setup menu.
Stereo
Modes
Audio In
Type
6.1
Direct
DSP
DRC
PL II
Neo 6
DD EX
DTS ES
LFE
Trim
Sub
On/Off
Tuner
AM/FM
Bass
Treble
ModeStore
Stereo
Mono
DisplayPTY APS
DVD Video 1 Video 2
Video 3
CD
Aux
Tape
MD/CDR
Enter
Vol
Vol