Filter
Top Products
OPTIONAL CONNECTIONS AND ADDITIONS
29
OPTIONAL CONNECTIONS AND ADDITIONS
Italiano SvenskaDeutsch NederlandsEnglish FrançaisEspañol
Using the IR emitter
If a component does not respond to the LIFESTYLE
®
system remote control commands,
the IR (infrared) signals may not be reaching it. Try moving the component or media center
slightly to see if that improves the response.
If there is still a problem, connect the supplied IR emitter to establish a solid response while
setting your LIFESTYLE
®
remote to control this component. You may not need to use the
emitter after that. Or keep it connected, as needed, for use with one component.
Note: For information on how to set the LIFESTYLE
®
remote to control the TV, refer to your
Operating Guide.
To connect the IR emitter:
1. Insert the plug into the IR Emitter connector on the media center connection
panel (Figure 20).
2. Place the other end of the cable near the component with the rounded surface of the
emitter facing the component.
3. Operate the component to see if it responds to remote commands. Move the emitter
around, if necessary, to find the best position.
4. Use the double-sided tape enclosed with the emitter to affix it in position near the
component.
Figure 20
IR emitter connector
location
Note: To purchase an add-on IR emitter for use with up to three components, or for replacement
of the supplied emitter, contact Bose
®
Customer Service. Refer to the address list included in the
carton.
Using a remote control antenna extender
If your system does not respond to remote control commands, but you know the remote
batteries are good, you may need to add an antenna extender to help the remote work within
its specified range. To contact Bose to purchase an extender, refer to the address list
included in the carton.
IR Emitter