Filter
Top Products
BASIC SYSTEM CONNECTIONS
13
Italiano SvenskaDeutsch NederlandsEnglish FrançaisEspañol
BASIC SYSTEM CONNECTIONS
1 Connect the speaker cables to the speakers
The speakers you have are one of the two types shown here. They differ in how the cables
connect to them.
Before you start, route the cables around your room. To make the rear speaker cables reach
each of the rear speakers, you can unzip the cables by simply pulling them apart.
Follow the instructions for the type of speakers you have.
Connecting Jewel Cube
®
speakers
Connecting array speakers
The cables for these speakers have a customized plug
that fits into the connector only one way (Figure 4).
A. Notice the marking on each cable plug and match it to
the speaker in that location:
• Front speaker cable plugs are marked L (left), R
(right), and C (center).
• Rear speaker cable plugs are marked LR (left rear)
and RR (right rear).
B. Orient the plug with its small knob up, so the plug slips
easily into a notch on top of the connector (Figure 4).
C. Insert the plug fully into the connector on the rear of its
respective speaker. For example, the plug marked L
connects to the speaker at the left front of your room.
Figure 4
Jewel Cube speaker connections
The cables for these speakers have wire ends that con-
nect to red and white connection terminals (Figure 5).
A. Notice the marking on the red collar on the speaker
cable and match it to the speaker in that location:
• Front speaker cables are marked L (left), R (right),
and C (center).
• Rear speaker cables are marked LR (left rear) and RR
(right rear).
B. Press the terminal tab to insert each wire into the
proper connector. Be sure to match the red-collared
wire to the red speaker connection terminal to maintain
proper + and – polarity.
Figure 5
Array speaker connections
Front and rear
left, right
speakers
Front center
speaker
Front and rear
left, right
speakers
Front center
speaker
Knob
Plug label: R, L,
RR, or LR
Plug label: C
Terminal tab
Wire label: L, R,
LR, or RR
Wire label: C