Filter
Top Products
BASIC SYSTEM CONNECTIONS
23
B
ASIC SYSTEM CONNECTIONS
English FrançaisEspañol
2. Put on the headset so it rests above your ears. In this position, it can listen (as you would)
and take sampling measurements in your room during the ADAPTiQ audio calibration
process.
3. Follow the calibration process as directed on the TV screen.
Save the headset for possible future use
When you have played both discs and followed their instructions, the installation of your
LIFESTYLE
®
DVD system is complete and its performance is tailored to the placement of your
system and your listening area.
You may want to customize your system again if you move it to another room or significantly
change the arrangement of the room by relocating furniture, the speakers, or the
Acoustimass
®
module. You can repeat the steps in “Making sure the sound is as good as it
gets” on page 21 at any time.
Keep the headset and discs together in their original carton and store them in a safe location.
Where to go from here
This completes the basic connection of your system and TV. Now you can:
• Refer to the Operating Guide for details on how to select system options and use the
controls for the fullest enjoyment of your home theater system as it is set up.
• Or, while the media center control panel is still readily available, you may want to install
the TV on/off sensor. Read the next section on this page to determine if you will
use the sensor.
• Or, if you prefer to add other components to the system now, continue with instructions
in “Connecting other components to the system” on page 27.
Installing the TV on/off sensor
The TV on/off sensor enables the system to automatically turn the TV on, as needed, when
another video source (DVD, cable/satellite box, etc.) is selected. If you choose not to use the
sensor, you need to turn on your TV separately. See Figure 21.
Note:
The TV on/off sensor is not included on LIFESTYLE
®
systems that use SCART
connectors.
With larger TVs you may want a second person to help as you follow the steps below:
1. Plug the sensor cord connector into the TV SENSOR jack on the media center.
2. Temporarily position the TV on/off sensor on the back of your TV as shown in Figure 21.
Note:
On a projection TV, the best place to mount the sensor is on the bottom rear of the
projector chassis. Front projectors with a separate screen may not work with the sensor, and
must be turned on and off manually, instead.