Filter
Top Products
20
BASIC SYSTEM CONNECTIONS
BASIC SYSTEM CONNECTIONS
EnglishFrançais Español
Your system is now ready for power
Note: Bose recommends using a high-quality surge suppressor on all electronics equipment.
Voltage variations and spikes can damage electronic components in any system. A quality sup-
pressor can eliminate the vast majority of failures attributed to surges and may be purchased at
electronics stores.
Connect the two AC power (mains) cords in the following order:
1. Plug the small end of the Acoustimass
®
module power cord into the AC power jack on
the connector panel of the Acoustimass module (Figure 16).
2. Turn the Acoustimass module POWER switch to on.
Figure 16
Power connection for
the Acoustimass module
3. If you have not plugged the small round connector of the media center power supply
cable into the DC POWER jack on the media center connection panel, do so now
(Figure 17).
Figure 17
Power connection for the
media center
Note: For dual voltage units (sold in certain areas), MAKE SURE the voltage setting on the
bottom of the media center power supply (Figure 17) matches the local power rating. Check with
local electrical authorities if you are not sure of the appropriate power rating.
4. Plug the other end of the power cord into an AC (mains) outlet.
OUTPUTSTO
CUBE SPEAKERS
AUDIO
INPUT
POWER
FRONT SURROUND
100-120/200-240VAC
50/60 Hz
350W MAX.
L
C
R
L
R
Acoustimass module
connector panel
POWER
| = ON
O = OFF
AC (mains)
outlet
Fully extend the cord between
the power supply and the
media center; it serves as
the remote control antenna.
Media center
power supply
Media center connection panel
DC
power jack