Filter
Top Products
22
BASIC SYSTEM CONNECTIONS
B
ASIC SYSTEM CONNECTIONS
EnglishFrançais Español
• Use Setup Disc 2 to follow the ADAPTiQ audio calibration process, which tailors the sound
of your LIFESTYLE
®
system very specifically to the acoustics in your room.
The special headset, designed to be worn above your ears, takes acoustic measurements
for you during the process. Put on the headset only when prompted by Disc 2.
Figure 19
Setup discs and AdaptiQ
audio calibration system
Setup Disc 1 ADAPTiQ
®
audio calibration system
Setup Disc 2
ADAPTiQ calibration headset
• Play both discs when all of the speakers are where you want them, your furnishings are
arranged as intended, and all of the system connections are completed.
• Allow approximately 30 minutes to complete the process.
• Begin the process when you are unlikely to be disturbed and when the acoustic measure-
ment tones (not loud, just weird) are unlikely to disturb anyone else.
Using System Setup Disc 1
1. Use the TV remote to turn on your television.
2. Select the TV Video input used to connect to the media center.
Note: If you wrote down which input you used on the provided form, refer to that form in “You
must select the proper TV Video input” on page 18
.
3. Lift up the media center front cover and press Open/Close on the control panel.
4. Insert Setup Disc 1 into the tray (label side up) and press Open/Close again.
5. Using the remote control, press the
CD/DVD
button.
6. Listen carefully as the disc begins to play and follow the simple instructions until Disc 1
tells you it is time to play Disc 2.
Using Disc 2 for ADAPTiQ
®
audio calibration
Replace Disc 1 with Disc 2 in the disc tray and continue with the steps below:
1. Connect the ADAPTiQ calibration headset to the AUX jacks on the connection panel of
the media center as shown below.
Figure 20
Using the AdaptiQ calibra-
tion headset
AUX
Media center connection panel
Headset