Bosch Appliances LE10 Radio User Manual


 
22 en | Operation LE10 Radio Receiver
F.01U.278.517 | V2.0 | 2012.11 User Manual Bosch Security Systems
Battery-low indication:
Relay 2 switches on for 2 seconds.
The red LED flashes for 2 seconds, then blinks 1 second
every 10 seconds.
For all MIYS35 and MIYS37 transmitters, the battery low status
is triggered when the transmitter is activated or with the daily
message. For all MIYN46 transmitters, the battery low status is
triggered only with the daily message.
6.9 Dual channel receiver (mode 9, only with
SW 1.10)
Programming and deleting of transmitters is done as in Mode 1.
Standby
The green LED stays permanently on.
The red LED is off.
Relay 1 is switched off.
Relay 2 is switched off.
When a transmitter, that is matched on a odd position (1, 3, 5,
etc.), is activated:
Relay 1 switches on for 2 seconds.
The red LED turns on for 2 seconds.
When a transmitter, that is matched on a even position (2, 4,
6, etc.), is activated:
Relay 2 switches on for 2 seconds.
The red LED blinks 1 second on, 1 second off, 1 second on.
Battery low indication (until the battery is exchanged)
The red LED flashes during 2 seconds, then flashes 1
second every 10 seconds.
NOTICE!
A MIYN46 transmitter in repeated alarm mode extends the
behavior of the LE10 by approximately 26 minutes. If several
MIYN46 transmitters are programmed, each activated
transmitter stops the sequence and starts its own sequence.