Filter
Top Products
LE10 Radio Receiver Programming | en 13
Bosch Security Systems User Manual F.01U.278.517 | V2.0 | 2012.11
5 Programming
5.1 Enter programming mode
To enter programming mode, press simply button T1 for the
desired time. See Section 4.1 Connecting ports, page 11.
5.2 Program a transmitter in modes 1, 2 or 5
To start programming
– Press button T1 for min. 1 second and max. 3 seconds.
Device behavior
– The green LED stays permanently on.
– The red LED blinks slowly for maximum 30 seconds.
Within these 30 seconds, activate the transmitter that you want
to match, the following behavior should be observed:
– The green LED and the red LED blink alternating for 6
seconds.
This indication confirms that the transmitter is programmed.
– If the transmitter is already programmed, then the red LED
blinks fast for 6 seconds after activating the transmitter.
– If 20 transmitters are already programmed, then the red
LED blinks fast for 10 seconds directly after activating the
button T1 between 1 and 3 seconds.
You can repeat the sequence with another transmitter.
NOTICE!
Both relays will not be activated in the programming mode.
NOTICE!
Per programming sequence only one transmitter can be
matched. You can program up to 20 transmitters.