Filter
Top Products
SAFETY PRECAUTIONS
PLEASE READ BEFORE INSTALLING
WARNING: to prevent fire or shock hazard, do not expose this unit to rain or moisture. Care should be taken to
prevent objects or liquid from entering the enclosure. Never handle the power cord with wet hands.
The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user of the presence of
uninsulated “dangerous voltage
” within the product’s enclosure that may constitute a risk of electric shock to you.
The exclamation point within an equilateral triangle is intended to alert the user of the presence of important
operating and maintenance (servicing) instructions in the literature accompanying the unit.
Caution: To prevent the risk of electric shock, do not remove cover. No user-serviceable parts inside
. Refer
servicing to qualified service personnel.
If an outdoor antenna is connected to the antenna input, be sure it is grounded to provide some protection against
voltage surges and built up static charges. Keep the outdoor antenna away from power lines.
Unplug the Preamplifier Tuner from the AC outlet when plugging in or unplugging cables, when left unused for an
extended period of time, moving the Preamplifier Tuner, or when you suspect lightning in your area.
Prevent damage to the power cord. Do not bend, pull, place objects on, alter, etc. Replace the power cord if it
becomes damaged. Always grasp the plug on the power cord when plugging in or unplugging the Preamplifier
Tuner from the AC outlet.
Your system may produce sound levels capable of causing permanent hearing loss. Do not operate for extended
periods of time at high volume levels.
Make sure the Preamplifier Tuner is placed on a level surface.
Protect the Preamplifier Tuner from impact. (Do not drop it!!!)
The Preamplifier Tuner is equipped with raised feet to provide ventilation, reduce acoustic feedback, and provide
protection against scratching the surface the unit is resting on. We advise against removing or altering feet.
Do not stack anything on top of the Preamplifier Tuner (amplifier, source, etc.) Leave a minimum of 3” clearance
from the top of the Preamplifier Tuner to the next shelf (or component).
The Preamplifier Tuner should be located away from heat sources such as heaters or amplifiers.
Do not perform any internal modifications to the Preamplifier Tuner.
Always connect the Preamplifier Tuner’s power cord to an unswitched AC outlet for normal operation.
If young children are present, adult supervision should be provided until the children are capable of following all
rules for safe operation.
Do not plug the Preamplifier Tuner’s power cord into an outlet with an unreasonable number of other devices. Be
careful if using extension cords and ensure the total power used by all devices does not exceed the power rating
(watts/amperes) of the extension cord. Excessive loads may cause the insulation on the cord to heat and possibly
melt.
Mistaking
CONTROL OUTPUT
or
IR INPUT
connectors for audio inputs or outputs may damage your Preamplifier
Tuner or other components.
Damage can occur to your speakers if the power rating of each individual driver is exceeded by the power
amplifiers connected to the Preamplifier Tuner. Ensure that all the drivers in your system are capable of handling
not only the average power being delivered by the power amplifier, but also the peak power that is likely to be
generated during strong passages.
If you are unsure of your speaker power rating, contact the speaker
manufacturer or the dealer where you purchased them.
The Preamplifier Tuner should be serviced by qualified personnel when:
The Preamplifier Tuner is not functioning properly.
The Preamplifier Tuner was exposed to rain or other type of moisture.
The Preamplifier Tuner was dropped, or the chassis is damaged.
1
P/N 13010 REV 0005
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN