Filter
Top Products
Source Names Setup
From the factory, your Preamplifier Tuner will display source names that match those printed on the rear of the
Preamplifier Tuner and on the supplied remote. However, this menu allows you to change the displayed names to
match the actual sources used. If you do not want to change the names then skip this step. Note that the tuner
name cannot be changed.
return to setup menu
(PRESET) and
↵
(ENTER)
MENU8
to rename additional sourcesrepeat 3-6repeat 3-67
until all renaming completerepeat 4-5repeat 4-56
move to new character positionVOLUME KNOB
(BAL L) or
(BAL R)
5
change blinking character
∧
(TUNE +) or
∨
(TUNE -)
or
4
select desired source for renaming
(SOURCE) step to source
desired source
3
enter source names menu
↵
( ENTER)
SEL or ENTER2
move to source names
From setup menu:
∧
(TUNE +) or
∨
(TUNE -)
From setup menu:
or
1
ActionFrom Front PanelFrom Remote
Source Levels Setup
This setup allows you to match the levels of your sources so that there are no large changes in volume as you
change from one source to another. This is for your convenience only and need not be performed unless you wish
to. You may use a SPL meter or your ear to adjust the levels. Note that the levels will depend not only on this
setting but also on the source material being played back. You may wish to use a test disc. Note that the only
setting permitted are 0 and -6dB.
return to setup menu
(PRESET) and
↵
(ENTER)
MENU6
set additional source levelsrepeat 3-4repeat 3-45
set desired levelVOLUME KNOB
(BAL L) or
(BAL R)
4
select desired source for level setup (SOURCE) step to sourcedesired source
3
enter source levels menu
↵
( ENTER)
SEL or ENTER2
move to source levels
From setup menu:
∧
(TUNE +) or
∨
(TUNE -)
From setup menu:
or
1
ActionFrom Front PanelFrom Remote
20
P/N 13010 REV 0005