Filter
Top Products
66
66
6
CHEVROLET-OLDS-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATIONCHEVROLET-OLDS-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATION
CHEVROLET-OLDS-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATIONCHEVROLET-OLDS-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATION
CHEVROLET-OLDS-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATION
INSTALLRADIOUSINGSAME
PROCEDUREASEXPLAINED
ONPAGES3AND4
SUB-DASHBOARD
(RADIOAREA)
MOUNTINGPLATEFROMKIT
(NOTINCLUDEDWITHRADIO)
FACTORYDASHPANEL
MOUNTINGSLEEVE
RADIO
DETACHABLEFRONTPANEL
REMOVALTOOLS
IMPORTANT
AMOUNTINGKITISREQUIRED
FORTHISINSTALLATION
CHEVROLET-OLDSMOBILE-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATIONCHEVROLET-OLDSMOBILE-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATION
CHEVROLET-OLDSMOBILE-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATIONCHEVROLET-OLDSMOBILE-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATION
CHEVROLET-OLDSMOBILE-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATION
All U.S. Made Cars, Trucks, and Vans Built Since 1982All U.S. Made Cars, Trucks, and Vans Built Since 1982
All U.S. Made Cars, Trucks, and Vans Built Since 1982All U.S. Made Cars, Trucks, and Vans Built Since 1982
All U.S. Made Cars, Trucks, and Vans Built Since 1982
Important-This radio cannot be installed in any "GM" vehicle without an installation kit. Refer to Kit Listings
on page 2 for the required kit. Complete kit installation is explained in the instructions included with kit. This
radio cannot be installed in GM vehicles built before 1982.
CAUTION: 1. DO NOT CUT OR FILE THE OPENING TO THE OUTER EDGES OF THE TEMPLATE!
2. FOR PROPER OPERATION OF THE CD PLAYER, THE CHASSIS MUST BE WITHIN 20° OF
HORIZONTAL. MAKE SURE THE UNIT IS MOUNTED WITHIN THIS LIMITATION.
1. Remove Existing Radio:1. Remove Existing Radio:
1. Remove Existing Radio:1. Remove Existing Radio:
1. Remove Existing Radio:
A. Remove existing radio dash trim panel surrounding the radio opening. This panel is usually secured
by screws and/or snap-in clips.
B. Remove the screws used to secure radio to the sub-dashboard.
Helpful Hint: If you do not have an existing radio, you will find the radio opening is covered by a
disposable cover plate.
C. Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.
D. Un-plug the wiring harness(es) and antenna cable and remove the radio.
2. Installthe New Radio:2. Install the New Radio:
2. Installthe New Radio:2. Install the New Radio:
2. Installthe New Radio:
A. Following the instructions included with the installation kit, secure the sleeve from the radio to the
mounting plate from the kit as explained on page 3.
B. Install the sleeve/mounting plate assembly to the sub-dashboard as per the instructions with the
installation kit.
C. Replace the dashboard trimpanel.
D. Following the instructions of steps 4 and 5 on page 4, carefully wire the radio and complete
installation into the mounting sleeve.