Filter
Top Products
55
55
5
CHRYSLER-DODGE-PLYMOUTH INSTALLATIONCHRYSLER-DODGE-PLYMOUTH INSTALLATION
CHRYSLER-DODGE-PLYMOUTH INSTALLATIONCHRYSLER-DODGE-PLYMOUTH INSTALLATION
CHRYSLER-DODGE-PLYMOUTH INSTALLATION
CHRYSLER-DODGE-PLYMOUTH INSTALLATIONCHRYSLER-DODGE-PLYMOUTH INSTALLATION
CHRYSLER-DODGE-PLYMOUTH INSTALLATIONCHRYSLER-DODGE-PLYMOUTH INSTALLATION
CHRYSLER-DODGE-PLYMOUTH INSTALLATION
All U.S. Made Cars, Trucks, and Vans Built Since 1974All U.S. Made Cars, Trucks, and Vans Built Since 1974
All U.S. Made Cars, Trucks, and Vans Built Since 1974All U.S. Made Cars, Trucks, and Vans Built Since 1974
All U.S. Made Cars, Trucks, and Vans Built Since 1974
Important-This radio cannot be installed in any U.S. made Chrysler, Dodge, or Plymouth without an
installation kit. Refer to Kit Listings on page 2 for the required kit. Complete kit installation is explained
in the instructions included with the kit.
CAUTION: 1. DO NOT CUT OR FILE THE OPENING TO THE OUTER EDGES OF THE TEMPLATE!
2. FOR PROPER OPERATION OF THE CD PLAYER, THE CHASSIS MUST BE WITHIN 20° OF
HORIZONTAL. MAKE SURE THE UNIT IS MOUNTED WITHIN THIS LIMITATION.
1. Remove Existing Radio:1. Remove Existing Radio:
1. Remove Existing Radio:1. Remove Existing Radio:
1. Remove Existing Radio:
A. Remove existing radio dash trim panel surrounding the radio opening. This panel is usually
secured by screws and/or snap-in clips.
B. Remove the two large screws used to secure radio to the sub-dashboard.
Helpful Hint: If you do not have an existing radio, you will find the radio opening is covered by a
disposable cover plate.
C. Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.
D. Un-plug the wiring harness(es) and antenna cable and remove the radio.
2. Installthe New Radio:2. Install the New Radio:
2. Installthe New Radio:2. Install the New Radio:
2. Installthe New Radio:
A. Following the instructions included with the installation kit, secure the sleeve from the radio to the
mounting plate from the kit as explained on page 3.
B. Install the sleeve/mounting plate assembly to the sub-dashboard as per the instructions with the
installation kit.
C. Replace the dashboard trimpanel.
D. Following the instructions of steps 4 and 5 on page 4, carefully wire the radio and complete
installation into the mounting sleeve.
FACTORYDASHPANEL
RADIO
REMOVALTOOL
MOUNTINGSLEEVE
INSTALLRADIOUSINGSAME
PROCEDUREASEXPLAINED
ONPAGES3AND4
SUB-DASHBOARD(RADIOAREA)
MOUNTINGPLATEFROMKIT
(NOTINCLUDEDWITHRADIO)
IMPORTANT
AMOUNTINGKITISREQUIRED
FORTHISINSTALLATION
HELP!
8:30am-7:00pmEastern
9:00am-5:00pmEastern
Monday-Friday
Saturday
1-800-645-7102
DETACHABLE
FRONTPANEL