Filter
Top Products
1212
1212
12
OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS
OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
7 MANUAL UP/DOWN TUNING ( / )
AUTOMATIC SEEK TUNING
Each time the side of this button is pressed,
the radio will tune one frequency step higher.
Similarly, each press of the side of the
button will tune one frequency step lower. To
manually tune in a station, press the button in
the appropriate direction until the desired fre-
quency is reached.
Pressing either side of the button for longer
than 0.5 seconds will activate the Automatic
Seek Tuning function in the selected direction
(as indicated by “UP” or “dO” on the display
panel). The radio will seek the next available
station and stop on that frequency.
8 PRE-SET SCAN TUNING (PS)
AUTO-STORE TUNING (AS)
During radio operation, press this button to
scan the 6 stations pre-set into the memories
of the band in use. The unit will stop at each
pre-set station for 5 seconds before continuing
to the next pre-set station (the preset number
on the display panel will flash during Pre-Set
Scan operation). Press the button again to
stop the Pre-Set Scan operation and remain
on the selected frequency.
Pressing the button for longer than 2 seconds
will activate the Auto-Store Tuning, which will
automatically scan the band and enter strong
stations into the pre-set memory positions for
that band (FMI and FMII bands if activated
during FMI band use). If you have already set
the pre-set memories of that band to your
favorite stations, activating the Auto-Store fea-
ture will erase those stations and enter the new
strong stations. The feature is most useful
when travelling in a new area where you are
not familiar with the local stations.
9 STATION PRE-SET MEMORIES
To set any of the 6 pre-set memory buttons,
use the following procedure:
1. Turn the unit on and select the desired band.
2. Select the first station to be pre-set using the
Manual or Seek Tuning functions 7 .
3. Press the pre-set button in until the number
of that pre-set button appears on the display
panel. The station is now set into the memory
of that pre-set button and can be re-called
by pressing the button momentarily.
4. Repeat the above procedure for the remain-
ing 5 pre-sets on the band in use and for the
other 2 bands of the unit.
bl LOCAL/DISTANT SELECTOR (LO)
During radio operation, this button is used to
select the “stop sensitivity” in the Automatic
Seek tuning mode. For the Local mode, press
the button so that the “LO” indication appears
on the display panel. In this mode, the radio will
only stop on strong local stations during Auto-
matic Seek operation. Press the button again
to select the Distant mode (“LO” will disappear
from the display panel), allowing the unit to
stop on a wider range of stations, including
weaker distant ones.
bm FMMONO/STEREOSELECTOR(ST)
During FM radio operation, this button is used
to select mono or stereo reception of the broad-
cast signal. Under normal reception condi-
tions, the unit should be left in the stereo mode,
indicated by “ST” on the display panel when a
stereo signal is being received. If the stereo
signal is too noisy for comfortable listening,
press the Mono/Stereo selector button bm to
switch to mono reception.