Filter
Top Products
4
INTRODUCTION
AUDIO FUTURA spa, AUDIO ANALOGUE producer and distributor, does not take any responsibility in the following cases:
Whenever the operational procedures related to the use and the maintenance of the equipment as described in this manual are not
respected.
Whenever damage to the equipment occurs because of repairs and modifications made form non-authorized staff or because of
normal deterioration of the system.
No part of this manual can be reproduced by any means, transmitted or copied for private or public use without private authorization
from AUDIO FUTURA spa.
The information contained in this manual is related to the data kept by AUDIO FUTURA spa at the moment of the issue o f this
publication; AUDIO FUTURA spa has the right to make changes to this document without prior notice.
The equipment has been projected and manufactured according to the Regulations of the Community 89/336/CEE and is marked CE.
This equipment cannot be used for different purposes other than those for which it has been manufactured.
AUDIO FUTURA spa does not take any responsibilities for accidents or damage due to improper use of the equipment.
WARNING
Please respect the safety standards contained in this manual before starting to operate the equipment.
Do not open the equipment. No further interventions than those described in this manual should be made. For technical assistance,
please consult a qualified technician or an AUDIO ANALOGUE dealer.
Not respecting the instructions contained in this manual will invalidate the terms and conditions of the guarantee.
NECESSARY PRECAUTIONS FOR SAFETY AND MAINTENANCE
ATTENTION: before starting any operation, using or maintaining the equipment, it is strictly necessary to understand the following
manual.
To avoid any accidents or hazards it is necessary to follow the following regulations.
Activate the equipment only prior to checking that the installation has been done properly, and conforms to the instructions contained
in this manual.
Avoid installing the equipment in places subjected to extremely high temperatures or humidity.
Check that the labels containing information about safety are always visible and in good condition.
Ensure not to obstruct ventilation and to avoid excessive overheating. The equipment should be kept to a minimal distance of 15 cm
from any object and not to be placed on carpet or other soft surfaces. Also installation close to radiators or in closed spaces without
ventilation should be avoided.
Do not switch on the equipment until it has been correctly and completely installed.
Only supply the equipment with the kind of the electric supply as stated on the appropriate label. If in doubt about the kind of supply
available, please consult an expert technician for technical assistance.
The equipment needs to be wired to an earth terminal. The external case is made of metal; a defective connection with the earth
may be dangerous.
In case damage occurs to the supply cable, it should be replaced immediately with the same kind of cable. This operation should be
only made prior to disconnecting the main supply.
Do not place objects on the supply cable and check that this is not positioned lying across a walk way. The cable should not be
knotted or curly.
Always replace the fuses with others of the same type.
Do not use the equipment close to water or other liquids. If liquid enters the equipment, the plug should be disconnected from the
socket avoiding any contact with the metal parts. Competent technical staff should be asked to check the equipment before
operating it again.
Do not place receptacles containing liquid on the equipment, even when it is switched off.
Keep the equipment far from sources of heat such as solar light, kitchens, radiators etc…
Always unplug the supply cable during rainy weather.
Always switch off and unplug the supply cable before cleaning the equipment externally: this operation should be made using a dry
and soft cloth. Never use alcohol based cleaning material.
If the amplifier was carried from an extremely cold environment to and extremely hot one, it could create internal condensation,
causing possible malfunction.
If this occurs, please wait for at least an hour before using it again, to allow it to gradually reach room temperature.
When not used for long periods, please unplug the equipment.
INSTRUCTIONS TO PUT IT OUT OF SERVICE
Consult qualified staff
Follow the regulations of the current legislation regarding recycling and waste disposal.