Audio Analogue SRL Verdi Cento Stereo Amplifier User Manual


 
20
TROUBLESHOOTING
Symptom Cause Remedy
Power cord incorrectly plugged in Make sure the power cord is correctly
plugged into the wall outlet
No led on
No sound
Burned-out fuses Check fuses in the fuse panel above
the IEC inlet (after unplugging the
power cord from the wall outlet)and
replace them with new ones of the
same type
Low volume Turn volume knob right
Faulty or incorrectly plugged signal
connectors between Verdi Cento and the
sources
Check cords and their connection
Off or incorrectly selected source Check if the source is on and active
and if it is correctly selected using the
in selector
Only one input led is on
No sound
Faulty or incorrectly plugged power cords
between Verdi Cento and the speakers
Check cords and their connection
Selected in leds are on, volume control
works but the leds are off, or selected in
leds are off and volume leds are on
Faulty or incorrectly plugged front panel Contact your Audio Analogue retailer
for connections check and front panel
substitution
Recording is impossible Incorrectly selected source Select the right source using the
recording selector and increase the
volume above 0 level
Remote controller doesn’t work No battery/ worn-out battery Place/replace battery (2 ‘AAA’
batteries)
You’re standing too far or on an exceeding
angle from the front panel
Get closer to the unit or reduce angle
Selected in leds are on, volume control
works but the leds are off, or selected in
leds are off and volume leds are on
Faulty or incorrectly plugged front panel Contact your Audio Analogue retailer
for connections check and front panel
substitution
If the suggested remedies do not work or the problem is not shown in the list above, please contact your local Audio
Analogue retailer.