Audio Analogue SRL Verdi Cento Stereo Amplifier User Manual


 
14
- Durante il normale funzionamento dell’apparecchio, selezionare una sorgente che stia riproducendo
musica, selezionare il livello di ascolto normalmente utilizzato, quindi mantenere premuto il tasto “Amp
Setup” del telecomando finché i leds del volume non cambiano il loro stato (come indicato nella
immagine seguente, che indica la posizione centrale, ossia nessuno sbilanciamento). Per quanto
riguarda il led degli ingressi continuerà ad indicare l’ingresso selezionato.
- Use the “VOLUME +” switch on the remote to decrease Left channel compared to Right, and use the
“VOLUME –“switch on the remote to decrease Right channel compared to Left one. The two illuminated
leds will rotate together to indicate the L/R balance.
- Utilizzare i tasti del telecomando “VOLUME +” per attenuare il canale di Sinistra rispetto al Destro e
VOLUME –“ per attenuare il canale di Destra rispetto al canale di Sinistra. I due leds accesi in alto si
muovono in coppia a destra o a sinistra indicando visivamente lo sbilanciamento.
Ex. Central L/R Balance
ES. Nessuno sbilanciamento
Ex.: Left channel 4dB less than Right
ES: Canale Sinistro 4dB minore del canale Destro
Ex. Right Channel 7dB less than Left one
ES: Canale Destro 7dB minore del canale Sinistro
- Push the “SETUP” switch on the remote to exit the setting procedure and come back to normal function
mode.
- Premere il tasto “Amp Setup” da telecomando per uscire dalla modalità di Regolazione del BALANCE e
ritornare nella condizione di normale funzionamento dell’apparecchio.
By Pass mode selection/Activation
This function permits the use of the VerdiCento as a power amplifier. To configure the product you have to select the Line Input
where you have connected the preamplifier and to activate the function with the remote after you turn on the unit. To set the unit
in Bypass mode do as follows:
- Turn on the unit pushing the front button.
- While the unit is performing the start up procedure to warm up the vacuum tubes, rotate the front
volume knob clockwise and keep it rotated, at the same time keep the front select input button pressed.
Keep on rotating the knob and pushing the select switch for some seconds (about 5 seconds) until you
see the up volume leds turning on as showed in the picture below